Solare-datensysteme Solar-Log Uživatelský manuál stáhnout pdf (Strana 166)

166

Phonosolar

PhonoCube 7.2 (Battery Hybrid System)

Procedure

1. Unscrew the cover according to the PhoneCube instructions.

2. If you are fabricating the cable yourself, connect the wires as shown in the following diagram.

Solar-Log™ terminal strip connector PhonoCube Terminal Strip

Terminal PIN

► 1 A/Data+

1 - Data+

► 4 B/Data-

2 - Data-

3. Screw the PhonoCube cover on again.

4. Insert the terminal block connector into the Solar-Log™ RS485 socket.

Connect the PhonoCubes to each other

•

Where to connect: Terminal strip under the cover on the backside.

Procedure

1. Unscrew the cover according to the PhoneCube instructions.

2. Connect the self-made RS-485 cable to the PhonoCube terminal block 1.

3. Connect the other end of the cable to the PhonoCube terminal block 2.

4. Connect additional PhonoCubes to each other in the same way.

5. Screw the inverter cover on again.

Allocate communication address

•

Recommendation: Continuous numbering from 1 to 247

•

Procedure: Start according to the PhonoCube instructions.

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 310 311

Žádné komentáře

Solare-datensysteme Solar-Log Uživatelský manuál Strana 166